Updating the destination list has failed

0, 0x00000000, The operation completed successfully. 3, 0x00000003, The system cannot find the path specified. 9, 0x00000009, The storage control block address is invalid. 11, 0x0000000B, An attempt was made to load a program with an incorrect format. 15, 0x0000000F, The system cannot find the drive specified. 17, 0x00000011, The system cannot move the file to a different disk drive. 23, 0x00000017, Data error (cyclic redundancy check) 24, 0x00000018, The program issued a command but the command length is incorrect.

7, 0x00000007, The storage control blocks were destroyed.

If the message is still shown, the network may be crowded. If multiple files were sent, use the Scanned Files Status screen to check for which file the problem occurred.

updating the destination list has failed-54updating the destination list has failed-13

Or you could disable SMB signing via the registry set both below values to 0 HKEY_LOCAL_MACHINE\SYSTEM\Current Control Set\Services\Lanmanserver\Parameters\Enablesecuritysignature HKEY_LOCAL_MACHINE\SYSTEM\Current Control Set\Services\Lanmanserver\Parameters\Requiresecuritysignature I wanted to give you a 1, but you're advising the user to change the registry first, and mentioning Group Policy as an afterthought.

The user really should be changing it via the Group Policy tool and not mucking around in the registry.

I have all permissions correct, I can get to the server through any device on the domain, and other devices not on the domain.

I feel like this is an authentication issue, but they say they are putting in the username and password ([email protected]) correctly.

And I am inclined to agree with them as I could not get it to work when I was on-site either.

FYI - just dealt with this issue on a SBS 2008 installation with a Savin 4060.

It is true that some previous models of Ricoh devices could not scan to a folder hosted on a W2k3 server if SMB signing was enabled, but this has not been the case for a number of years. Ricoh are releasing firmware for almost all devices to support SMB v2 during early 2010. I didn't change any group policy, but I did have to set the scanner to search for the server by IP address rather than network name.

Please be aware that all Ricoh devices CAN scan to a shared folder on Windows 2008 servers. That is, it is saving to \10.15.1.50\Scans rather than to \Newport\Scans.

In the administrator mode, select [Network] - [LDAP Setting] - [Setting Up LDAP] - [Edit], then configure the following settings.

Cannot browse network and find SBS server shared folder from Copier Setup SMB to shared folder Authenticate using admin user name and password Copier cannot connect. I have setup numerous copiers to scan to folder in a Windows Server 2003 environment. You may need to disable it on the SBS server if this is the case.

During nagging Adobe is checking the network connectivity.

Tags: , ,